Features

• • USB Type-C and USB PD
    

  - USB PD 3.0 with Programmable Power Supply (PPS)
  

  - USB PD 3.1 SPR
  

  - Dual Role Port (DRP)
  

  - programmable pull-up Rp or current source
  

  - pull-down Rd
  

  - 100mW Vconn power and switches
  

  • USB BC1.2 DCP, QC3+/QC4+ HVDCP, FCP/SCP, AFC, VOOC and UFCS protocol
    
  • Supports the control interfaces of opto-coupler, FB pin & I2C type ACDC PWM controllers
    

  - programmable constant voltage
  

  - programmable constant current
  

  - high side current sense with programmable gain amplifier (PGA)
  

  - programmable cable drop compensation
  

  • Programmable fault protections
    

  - Over Voltage Protection (OVP)
  

  - Under Voltage Protection (UVP)
  

  - Over Current Protection (OCP)
  

  - Over Temperature Protection (OTP)
  

  • High voltage (30V) CC1/CC2/DP/DM pins
    
  • OVP for CC1/CC2/DP/DM
    
  • DP/DM low impedance detection: 100Ω (min.) to 430Ω (max.)
  • USB Std-A and USB-C port plug-in detection pins
  • 10-bit ADC for voltage and current monitoring
  • MCU
    

  - 1T-8051
  

  - 32K bytes flash memory with EEPROM emulation
  

  - 1.5KB SRAM
  

  • NMOS drivers for USB-C port load switch
    
  • PMOS driver for USB Std-A port load switch
    
  • Built-in discharge MOS transistor
    
  • Internal 24MHz & 65kHz RC OSC
    
  • Internal VDD & V18 regulators
    
  • 1 master/slave I2C and 1 slave I2C
    
  • Constant current output for LED control of power bank application
    
  • High speed PWM for DCDC output voltage control
    
  • Operating voltage range: 3V to 30V
    
  • Operation current: 8mA (typ.)
    
  • Standby current: 100μA, with CC/DP/DN pins and cable wake up
    
  • Operating temperature range: -20°C to +105°C
    
  • Package: 16-pin/24-pin QFN, 4*4mm2
    
  • In-System-Programming (ISP)/Writer with or without authentication for vulnerability issue